Model Controllers |
A Model Controller system that is as smart as it is powerful.
OSRC is a powerful system with many new and exciting features. A powerful control system requires a control unit just as powerful and versatile. It was inevitable to have dedicated control units, specifically designed for OSRC simply because there are no counterparts that could execute functions OSRC is capable of. Besides the fact that the Mark 1 controller contains a modular system for expandability as well as the RF equipment required for Cloud Communications, it also executes functions normally obtained by using expensive RC equipment such as channel Mixing and synchronization.
Although we do provide a smaller counterpart such as the Mark 2 unit, the Mark 1 controller gives greater range of control due to its SMA antenna connection as well as a more powerful RF unit which combined with the on-board controller and a rich set of features give your model the ability to perform motions and maneuvers simply not possible with currently available RC hardware, without additional equipment and greater expenses.
All model controllers we provide have many original and flexible features. One of those features is the ability to expand hardware such as channel count, connect additional modules such as FPV, GPS or others and produce an amazing result, which is as small as a model might require, without taking much space or power.
Since the OSRC line of Model Controllers communicates the same way as everything else, through an RF Cloud, it is possible to increase the signal strength by simply applying additional stations between the operator and the model or the other way around. By increasing the model count in your flying area, you increase your signal strength as well as data transmission reliability.
Scenarios where one model is the intermediate RF expander for the next model are possible, giving almost an unlimited range of functionality for both professional as well as hobby fields.
Exterior Features
|
Hardware Features
|
Software Features
|
Latest Blogs
Latest Forum Posts
-
-

- when you are posting somes videos on youtube?
- In OSRC Community / Suggestion Box
- 2 days 22 hours ago
-
-
-

- Larger printer.
- In OSRC Community / General
- 1 week 9 hours ago
-
-
-

- Lead Time
- In 3D Printing / Ilios HD 3D Printer
- 1 week 13 hours ago
-
-
-

- Dell 2400mp
- In 3D Printing / Ilios HD 3D Printer
- 1 week 2 days ago
-
Last Updated Files
Latest Comments
-
9 - Electronics Assembly
5 days ago
Glad you like the idea. Hope to have you as a customer soon :) -
9 - Electronics Assembly
5 days ago
Thanks for the quick answer. Good news about the controller. I am sure you understand my concerns. -
9 - Electronics Assembly
5 days ago
Dear Jorge, I didn't have any problems with the board if it is set up as described. As you shall see ...
At-last, the hard part is behind us. The Ilios machine produced its first results. The initial build, seen in this image was a test not only for the functionality of the machine but also for its endurance since during the build there were lots of tests done, like adding weights to the build lift, messing with the motors and doing stress tests while the machine was working. Needless t
Finally after many days in testing and development i can now proudly say that our Ilios HD machine is working. Although the last component for our first build hasn't arrived yet (PDMS for the Vat surface), all mechanics operate flawlessly and i even did a test print with the projector setup mentioned in our Facebook page.
At last all the parts needed for the 3D printer build arrived. It took some time for the main components (mechanics) to get here but once i received the crate, it became clear why. The package weighed over 280kg and was very nicely sealed in a wooden crate. All the aluminum extrusions, spindles, fastening hardware
Although things may seem to have gone quiet, after the IndieGoGo campaign finished, a lot of things have been happening behind the scenes and on the website. First off, few days after the campaign was funded, all parts have been ordered. I am happy to say that the last projectors shall be picked up on Monday (25/02/2013) since






